herunterladen
1 of 20
© 2014 TE Connectivity family of companies
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
TOOLING ASSISTANCE CENTER
1-800-722-1111
PRODUCT INFORMATION
1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
Application Specification
114-13120
22 DEC 14 Rev K
NOTE
All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters. Unless
otherwise specified, dimensions have a tolerance of ±0.13 mm and angles have a tolerance of ±2°. Figures and illustrations
are for identification only and are not drawn to scale.
1. INTRODUCTION
This specification covers the requirements for application of SFP, SFP+, and zSFP+ surface mount PT
connectors and cage assemblies to interconnect SFP, SFP+, and zSFP+ fiber optic or copper transceiver
modules to printed circuit (pc) boards. The connectors are available in 20, 30, 40, and 70 positions with contact
spacing on 0.8 mm centerlines; however, ONLY the 20-position connector is designed to be used with these
cage assemblies. The cage assemblies are available in single port or ganged 12, 14, or 16 configurations (two,
four, or six adjoined ports), and with or without a light pipe. The light pipe is used to transmit light from an LED
on the pc board to a panel (information for cage assemblies with light pipe is not included in this document).
Each cage assembly is designed to be inserted into a bezel after being seated onto the pc board.
The connector is supplied in tape-and-reel form for manual or high-speed automatic machine placement
(typically vacuum pick and place). The cage assemblies are supplied in plastic tray packaging for manual
placement.
When corresponding with TE Connectivity Personnel, use the terminology provided in this specification to
facilitate inquiries for information. Basic terms and features of this product are provided in Figure 1.
Figure 1 (cont’d)
Small Form-Factor (SFP), SFP+,
and zSFP+ Surface Mount PT
Connectors and Cage Assemblies
SFP/SFP+ Connector
16Gb/s SFP+ Connector
Pin 1 Identifier
Housing
Chamfered
Corner
Card Entry
Slot
Housing
Card Entry
Slot
Standoff
(2 Places)
Standoff
(2 Places)
Surface Mount Contact
(Ref)
Surface Mount Contact
(Ref)
Alignment Post
(2 Places)
Alignment Post
(2 Places)
zSFP+ Connector
Card Entry
Slot
Housing
Standoff
(2 Places)
Alignment Post
(2 Places)
Surface Mount Contact
(Ref)
